Electronics LP2000_VAR User Manual download pdf (Page 4)

Fig. 4 This figure shows the original

operating amperage level, in this case

approximately 24 amps. The operator

was unable to confirm if this meter was

calibrated. Later tests indicated a 4

amp error.

Fig. 5 The first step in removing the

old mechanical valve is to remove the

feed spout going to the wheel inlet.

First, remove the four bolts attaching

the feed spout to the bottom of the me-

chanical valve.

Caution: Be sure the wheel is not rotat-

ing and that the machine is properly

locked out. Follow all safety precau-

tions and instructions shown on the ma-

chine or in the owner’s manual.

Fig. 4

Fig. 5

1 2 3 4 5 6 7 8 9 ... 12 13

No comments

Electronics LP2000_VAR User Manual Page 4