Electronics WM 3000-24 User Manual download pdf (Page 4)

Installation

MagnaValve

The MagnaValve must be mounted in a vertical position with an adequate supply of

media above it.

Remote Valve Driver

The Remote Valve Driver should be mounted in an electrical panel that conforms to

the temperature range of 50˚- 120˚ F (10˚- 49˚ C).

Adjustments

MagnaValve

No adjustments are required or recommended. The valve has been tested at the

factory prior to shipment.

Remote Valve Driver

Adjustments to the Remote Valve Driver can be made from the front of the driver;

however, the factory settings should not be changed. The output signal is 10 Vdc. See

page 5 for additional information on the Remote Valve Driver.

Operation

MagnaValve

Signals used to operate the MagnaValve originate at the AC-24 Controller. There are

three conditions necessary for correct operation.

1) Power. 24 Vdc power must be continuously applied to the valve. The valve

requires 2 Amps for operation and a power supply rated at 50 Va. The voltage

should be 24 ±2 Vdc.

2) Enable Signal. The 24 Vdc Enable Signal is used to activate the valve.

3) Input Signal. The analog 0-10 Vdc input signal must be above 0.25 Vdc as a

minimum ow command signal.

AC-24 Controller Operation

Please download the AC-24 Instruction Manual

http://www.electronics-inc.com/data_sheets_and_instruction_manuals_for_wheel_blast_machine_products2.html

1 2 3 4 5 6 7 8 9 10

No comments

Electronics WM 3000-24 User Manual Page 4